Предварительно DirectX Graphics Driver-драйвер dxg.sys.
Желательно еще парочку дампиков,вечером прогоню дебагом-там информация более конкретная будет.
Добавлено через 23 минуты 6 секунд
A problem has been detected and Windows has been shut down to prevent damage
to your computer.
The problem seems to be caused by the following file: dxg.sys
KERNEL_MODE_EXCEPTION_NOT_HANDLED
If this is the first time you've seen this stop error screen,
restart your computer. If this screen appears again, follow
these steps:
Check to make sure any new hardware or software is properly installed.
If this is a new installation, ask your hardware or software manufacturer
for any Windows updates you might need.
If problems continue, disable or remove any newly installed hardware
or software. Disable BIOS memory options such as caching or shadowing.
If you need to use safe mode to remove or disable components, restart
your computer, press F8 to select Advanced Startup Options, and then
select Safe Mode.
*** dxg.sys - Address 0xbd00400e base at 0xbd000000 DateStamp 0x47cff3ed
A problem has been detected and Windows has been shut down to prevent damage
to your computer.
The problem seems to be caused by the following file: ntoskrnl.exe
BAD_POOL_CALLER
If this is the first time you've seen this stop error screen,
restart your computer. If this screen appears again, follow
these steps:
Check to make sure any new hardware or software is properly installed.
If this is a new installation, ask your hardware or software manufacturer
for any Windows updates you might need.
If problems continue, disable or remove any newly installed hardware
or software. Disable BIOS memory options such as caching or shadowing.
If you need to use safe mode to remove or disable components, restart
your computer, press F8 to select Advanced Startup Options, and then
select Safe Mode.
WARNING: Unable to verify timestamp for win32k.sys
*** ERROR: Module load completed but symbols could not be loaded for win32k.sys
*** WARNING: Unable to verify timestamp for dxg.sys
*** ERROR: Module load completed but symbols could not be loaded for dxg.sys
( win32k+2a90 )
Добавлено через 16 минут 48 секунд
1000008E, {c0000005, bd00400e, a8395c6c, 0}
Ошибка может быть вызвана следующим:
1. Один или несколько RAM модулей установленных на вашем компьютере не исправны.
Протестируйте оперативную память на ошибки.
2. Конфигурация RAM не совместима с Windows.
3. Довольно часто такая ошибка наблюдается, когда компьютер заражен одной из разновидностей вируса HaxDoor.